I have been working on my Thesis with CODESYS V3.5 SP16 with Berghof DC-Pro 4,3" S05 controller for my runtime. I integrated CODESYS and Visual Components 4.2 for my robot digital twin through OPC UA. The problem is if I connect the application program with the device controller and run, application starts running but after a few seconds application stops automatically. So the basic problem I found is if I run previous fresh code it's okay and runs smoothly but if I add OPC UA or anything in my CODESYS program application for further tasks, the problem occurs. Would you like to provide me some information regarding this issue. Is there anything that I am missing for my program to integrate with OPC UA? From my main program I got two main errors "pPixamp is not valid" and "Checking slaves:perhaps slave is missing,mismatch to configuration or no communication at all". I would be privileged to have some suggestions to mitigate those errors.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have been working on my Thesis with CODESYS V3.5 SP16 with Berghof DC-Pro 4,3" S05 controller for my runtime. I integrated CODESYS and Visual Components 4.2 for my robot digital twin through OPC UA. The problem is if I connect the application program with the device controller and run, application starts running but after a few seconds application stops automatically. So the basic problem I found is if I run previous fresh code it's okay and runs smoothly but if I add OPC UA or anything in my CODESYS program application for further tasks, the problem occurs. Would you like to provide me some information regarding this issue. Is there anything that I am missing for my program to integrate with OPC UA? From my main program I got two main errors "pPixamp is not valid" and "Checking slaves:perhaps slave is missing,mismatch to configuration or no communication at all". I would be privileged to have some suggestions to mitigate those errors.
Him
you need to check the plc logger fpr more and detailed information.
I'm having this error. I looked through all the detailed information but haven't got any clue to solve the issue