Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am using a raspberry pi cm 4 with codesys and have had success for the most part, but recently have been getting an error when trying to login and connect to the raspberry pi. The error reads "invalid result package" and is shown in an attachment below. This error will then not allow me to log on. I have tried previous versions of the same project and have had these issues as well. The project had been working perfectly for a while before this and I cannot figure out what has caused this problem. I did just recently re flash the raspberry pi as a separate issue was occurring but the program did work repeatedly on the raspberry pi before the issues began.
Hello,
I am using a raspberry pi cm 4 with codesys and have had success for the most part, but recently have been getting an error when trying to login and connect to the raspberry pi. The error reads "invalid result package" and is shown in an attachment below. This error will then not allow me to log on. I have tried previous versions of the same project and have had these issues as well. The project had been working perfectly for a while before this and I cannot figure out what has caused this problem. I did just recently re flash the raspberry pi as a separate issue was occurring but the program did work repeatedly on the raspberry pi before the issues began.
Any help would be appreciated!
Thank you.
I am also running into issues with this Error message. I tend to get this message more often when i try to remotly load my raspberry pi through vpn.
if this happens check the plclog for more details (login by ssh client to the pi):
cat /tmp/codesyscontrol.log