Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I would like to ask you about Redundancy Sync problem.
I am using two Raspberry pi SL and I set redundancy configuration and it wrote in 'CODESYSControl_User.cfg'.
Also, I checked that a boot application was created and it synced without any problems.
However, when I turn off the power of both RPis and turn them on at the same time.
The redundancy state remained [Standalone - Standalone] as shown in the attached file.
How could I make them sync automatically? when I turn them on at the same time.
Is there any required setting for this?
Hello, everyone
I would like to ask you about Redundancy Sync problem.
I am using two Raspberry pi SL and I set redundancy configuration and it wrote in 'CODESYSControl_User.cfg'.
Also, I checked that a boot application was created and it synced without any problems.
However, when I turn off the power of both RPis and turn them on at the same time.
The redundancy state remained [Standalone - Standalone] as shown in the attached file.
How could I make them sync automatically? when I turn them on at the same time.
Is there any required setting for this?
BR