Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

SPI Master not running/MCP3008 Missing driver.

  • spareparts - 2023-09-12

    I believe I have installed the correct device descriptions and library, in an attempt to use the MCP3008 in conjunction with RPI; when project runs the MCP3008 is unable to find the correct driver. Is there anything I'm missing? Very new to this so any help is apprecated!

  • eschwellinger

    eschwellinger - 2023-09-12
    1. SPI enabled on 'sudo raspi-config'
    2. reduce _diMaxSpeed
  • spareparts - 2023-09-13

    Up and running thank you.


Log in to post a comment.