Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi.
Is it possible to connect a softmotion axis to a servo drive on runtime (with IEC code)?
for example,
1) fbAxis is an instance of AXIS_REF_ETC_Panasonic_MINAS..
2) Ethercat type Panasonic MINAS servo is added to Ethercat Master with Ethercat stack library (dynamic configuration ,not in the device tree)
I'd like to connect this fbAxis to the Panasonic servo.
Your help would be appreciated.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi.
Is it possible to connect a softmotion axis to a servo drive on runtime (with IEC code)?
for example,
1) fbAxis is an instance of AXIS_REF_ETC_Panasonic_MINAS..
2) Ethercat type Panasonic MINAS servo is added to Ethercat Master with Ethercat stack library (dynamic configuration ,not in the device tree)
I'd like to connect this fbAxis to the Panasonic servo.
Your help would be appreciated.