Hi i try to install this runtime on a PC
when i try to configure the ethernet card: currently intel I210 or Intel I217-LM
i can not install the generic Driver ‘CmpEt1000Drv’
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I solve that issue, where i am suppose to configure the IP adress of my RTE PLC?
i think in CodesysControl_User file but where and how ?
i need to configure alse the option webvisu that i have ordered but i do not have any installation guide
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
you do not need to configure it in any config file, just use the Windows network configuration to do this.
CODESYS do a scan and will find the RTE no matter if you use dhcp or static ip configuration on Windows.
If you are talking on Ethercat network or Profinet or EIP network card selection, this will be done in the CODESYS projekt
by browsing the network interface.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
thanks
i have configure the cmpEt1000 drv, but it seems that my port is blocked on 100mega, i can see it on my switch, is there a way to change that and unlock gigabit ?
Hi i try to install this runtime on a PC
when i try to configure the ethernet card: currently intel I210 or Intel I217-LM
i can not install the generic Driver ‘CmpEt1000Drv’
I solve that issue, where i am suppose to configure the IP adress of my RTE PLC?
i think in CodesysControl_User file but where and how ?
i need to configure alse the option webvisu that i have ordered but i do not have any installation guide
you do not need to configure it in any config file, just use the Windows network configuration to do this.
CODESYS do a scan and will find the RTE no matter if you use dhcp or static ip configuration on Windows.
If you are talking on Ethercat network or Profinet or EIP network card selection, this will be done in the CODESYS projekt
by browsing the network interface.
thanks
i have configure the cmpEt1000 drv, but it seems that my port is blocked on 100mega, i can see it on my switch, is there a way to change that and unlock gigabit ?