Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
A couple of years ago, I ran some tests with MODBUS TCP communication between rPi running CodeSYS and a couple of Arduino's.
I remember that I could set all the parameters under the MODBUS devices.
I am now trying to run another test, and I can't seem to find where to set the IP address for my SLAVE/SERVER. Am I correct to assume that this is set through a FB now?
Nor am I able to find any free libraries on the CodeSYS site. Am I looking in the wrong place?
Any help would be greatly appreciated!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi all,
A couple of years ago, I ran some tests with MODBUS TCP communication between rPi running CodeSYS and a couple of Arduino's.
I remember that I could set all the parameters under the MODBUS devices.
I am now trying to run another test, and I can't seem to find where to set the IP address for my SLAVE/SERVER. Am I correct to assume that this is set through a FB now?
Nor am I able to find any free libraries on the CodeSYS site. Am I looking in the wrong place?
Any help would be greatly appreciated!