Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Dear all,
in my project I'm using Raspberry PI B+. I need quite a number of inputs. Everything is working, but not GPIO 5 and 6. Both are always TRUE. (See pictures) What is wrong with my programming?
Than you very much for your reply.
Joachim
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi ZorAxe,
I have all inputs connected to the GPIO's. It seems to me that GPIO's 4, 5, and 6 are used for other things. Therefore I changed my input signals to GPIO 9 and 10 and it is working now.
Thank you very much for your support.
Best Regards
Joachim
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
JJoe hat geschrieben:
Hi ZorAxe,
I have all inputs connected to the GPIO's. It seems to me that GPIO's 4, 5, and 6 are used for other things. Therefore I changed my input signals to GPIO 9 and 10 and it is working now.
Thank you very much for your support.
Best Regards
Joachim
Joachim,
Could you share with me what your physical wiring looks like? I am having trouble getting inputs working with CodeSys. Do you have resistors in your circuit? Did you wire your inputs to GND or to 3.3V?
Thanks in advance,
Krys
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Dear all,
in my project I'm using Raspberry PI B+. I need quite a number of inputs. Everything is working, but not GPIO 5 and 6. Both are always TRUE. (See pictures) What is wrong with my programming?
Than you very much for your reply.
Joachim
How have you connected the inputs to the GPIO's?
Hi ZorAxe,
I have all inputs connected to the GPIO's. It seems to me that GPIO's 4, 5, and 6 are used for other things. Therefore I changed my input signals to GPIO 9 and 10 and it is working now.
Thank you very much for your support.
Best Regards
Joachim
Joachim,
Could you share with me what your physical wiring looks like? I am having trouble getting inputs working with CodeSys. Do you have resistors in your circuit? Did you wire your inputs to GND or to 3.3V?
Thanks in advance,
Krys
Finally got my inputs working last night, here is the wiring diagram that I used to make it work.