Hi All,
I use the analysis page in automation server to capture historical trends from my PLC - i only sample one point per hour but it does the job (for now)
One issue I have is I often log on to analysis page to find the system has stopped recording trends from my PLC.
To fix this, I need to choose "state information" in the "List view" under PLC and click "Reconnect"
When I do this I see my variables listed under "parameters" under "PLC Details" start updating again and the trend in Data analyzer continues to update.
My Question, Why do I need to manually reconnect?
Is there a way to get automation server to automatically reconnect to the PLC so I continue to capture data from the PLC?
Regards,
Trent
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Edge controller Version: 4.4.0.0 based on 3.5.17.30
PLC version:
Device Identification
Name CODESYS Control for Raspberry Pi MC SL
Vendor 3S - Smart Software Solutions GmbH
Device type Softmotion3S
Firmware version 4.4.0.0
Hi All,
I use the analysis page in automation server to capture historical trends from my PLC - i only sample one point per hour but it does the job (for now)
One issue I have is I often log on to analysis page to find the system has stopped recording trends from my PLC.
To fix this, I need to choose "state information" in the "List view" under PLC and click "Reconnect"
When I do this I see my variables listed under "parameters" under "PLC Details" start updating again and the trend in Data analyzer continues to update.
My Question, Why do I need to manually reconnect?
Is there a way to get automation server to automatically reconnect to the PLC so I continue to capture data from the PLC?
Regards,
Trent
Hi Trent,
yes should work without, let me check.
Regards
Edwin
Could you please check which EdgeGateway Version is up and running?
Hi Edwin,
Thanks for your message.
Edge controller Version: 4.4.0.0 based on 3.5.17.30
PLC version:
Device Identification
Name CODESYS Control for Raspberry Pi MC SL
Vendor 3S - Smart Software Solutions GmbH
Device type Softmotion3S
Firmware version 4.4.0.0
Last edit: tmo21 2024-10-23
latest Edge should solve it