Activity for arnog

  • arnog arnog posted a comment on discussion Motion πŸ‡¬πŸ‡§

    I am also looking for the right solution. Also saw a virtual axes would be better to steer x1 and x2

  • arnog arnog posted a comment on discussion Motion πŸ‡¬πŸ‡§

    Hi TK_Jenssen did you found a solution I am setting up the samelike gantry only with two z-axes which are mounted on fix position with an X axes between the two z-axes. The movement and position of both z-axes must be very well aligned and calibrated. Maybe also to be adjusted by programming. Can you sent an example of your solution?

  • arnog arnog posted a comment on discussion Engineering πŸ‡¬πŸ‡§

    Hi Liuk89 I don't know but are you following a g-code?

  • arnog arnog posted a comment on discussion Motion πŸ‡¬πŸ‡§

    How to setup two synchronised axes in Z direction these are absolute mortors with automatic brake when power failes. I want to have them aligned in position and movement. What would be the best Virtual axes connected with both axes to do master slave or only one master slave between the two axes. Can I also have a control on this with function blocks.

  • arnog arnog posted a comment on discussion Engineering πŸ‡¬πŸ‡§

    Hi Liuk I dont see a attached figure

1