Hello, I modified your example a little bit so it will work with J1939 ECU devices in the device tree. Now it is possible to disable the J1939 ECU and it stops sending CAN messages. But when I want to enable it again, device in the device tree becomes active (not grayed out anymore) but it doesn't send data. The state of the J1939 ECU device stays disabled, does anyone have experience with enable/disable J1939 ECU devices. The 1939 ECU device is marked as local device. Talk Topic about project #...
Hello, Within codesys 3.5 it is possible to change the language with a variable. Is the same possible within codesys V2.3. What I want is by a change of variable LangSelection the language is changed. Let say, if LangSelection = 1, language is English and when value is 2 language is German.
Hello, Did you find a solution for it. I want to change language with a variable. Within codesys 3.5 I did this before but know I have a controller which must be programmed with V2.3 and I was wondering if change of language could be done with a variable.