Hallo, wir sind etwas Ratlos mit der Handhabung der EVL/EVCs in Verbindung mit IFM CR7xxs Steuerungen. Uns ist aufgefallen, bzw. schon mehrfach passiert, dass ein Programmierer ein Projekt fertig stellt, dieses auf Freigegeben stellt und abschließt. Wenn ein zweiter Programmierer das Projekt öffnet und sich in die Steuerung einloggen möchte ist dies nicht möglich ohne Download. Es wird dann immer angezeigt, dass sich die EVC geändert haben obwohl im Programm nichts verändert wurde. Gibt es eine Einstellung...
Hallo Forums Gemeinde, hat jemand von euch eine Idde ob und wie es möglich sein könnte die Einstellungen was für die Netzwerk variablen Liste nötig sind, also Broadcast IP, Port usw., über die Application einzustellen? Ich müsste je nach Projekt immer die IP anpassen, da auf den Anlagen die Software Identisch bleibt, wäre es für mich viel einfache diese Einstellungen über den Code einzustellen. Wenn man so im Forum sucht gibt es nicht viel was NetVar angeht... Grüße Andy
Hi Edwin, also with putting in the IP directly won´t work. The Device is Pingable, but Codesys can´t find and connect. I Attach my routing Table. Where the x.x.1.5 is the TTC, the x.x.255.0 is the VPN IPnet, the 10.0.0.0 is the Wired WAN net. I tried a Connection with the Hercules Tool with Port 1217 (TCP + UDP), the Port are not locked and the Messages passes well in both directions. Are you shure that a Missing Default GW on the TTC won´t affect this problem?
I have a similar problem with a TTC580. The TTC is connected by a router over a VPN where i made an iroute to the net of the TTC. By scanning the Net of the TTC I can't find the device. I use Codesys SP10 as recommanded by TTcontrol. I tried also with the 3.5.16.x edge Gateway without success. Any ideas? The Device don't has a default Gateway set on it (is not implemented). Don't know if can cause this the problem?
use {attribute 'subsequent'} and this problem is solved
problem Gelöst !! size muss LWORD Bei 64Bit sein und size kann DWORD Bei 32Bit sein
May i am a little late... Start the PLC in the Bootloader mode with the TTC-Downloader. Click Connect in the TTC Software, if you see the Message Box to Perform the power cycle, plugin and the see the Magic. Or Connect the Out +5v1 and +5v2 to ground, so the Device Boots in Bootloader Mode with Default IP and Default Settings. No Application will start with the 2 Wires to ground. Then erase your Application with the Downloader.
May i am a little late... Start the PLC in the Bootloader mode with the TTC-Downloader. Click Connect in the TTC Software, if you see the Message Box to Perform the power cycle, plugin and the see the Magic. Or Connect the Out +5v1 and +5v2 to ground, so the Device Boots in Bootloader Mode with Default IP and Default Settings. No Application will start with the 2 Wires to ground. Then erase your Application with the Downloader.