Gentleman OMG, I made a huge mistake when i tried and moved shaft by hand i hold cover(as on photo) in my fingers. I was convinced that shaft has key but it there is not key. So when i turn cover it slide on shaft. When i take off cover and drive is in standstill, shaft does not move. So everything works perfectly
Gentleman OMG, I made a huge mistake when i tried and moved shaft by hand i hold cover(as on photo) in my finder. I was convinced that shaft has key but it there is not key. So when i turn cover it slide on shaft. When i take off cover and drive is in standstill, shaft does not move. So everything works perfectly
Gentelman OMG, I made a huge mistake when i tried and moved shaft by hand i hold cover(as on photo) in my finder. I was convinced that shaft has key but it there is not key. So when i turn cover it slide on shaft. When i take off cover and drive is in standstill, shaft does not move. So everything works perfectly
Ok, it is clear. But Is it normal when i move shaft by hand actual position stops?
Hello, Thank you for your response. In my application i use ethercat and while work i do not turn off power. After relative move motor is in standstill. As you suggest I suppose that problem is in drive setting but i do not see any option about increase standstill torque. Below i posted some photos from drive setting manager - PSD Servomanager Do you see any settings responsible for standstill torque? thank you
Hello, I using codesys motion with Parker servo (without brake). In my application i use mc_moverelative. When i send new position motor moves. But when it arrives to the point it stops and does not hold the position. It means that i can easily move shaft by hand Should i somewere turn it on so motor keep position by torque (current)? Best regards Lukasz
Hello, Is it possible to find function block flying shear? Or i have to prepare myself? best regards Lukasz