Personal Data

Username:
kumareasu
Joined:
2020-01-17 11:54:21+00:00

Projects

  • No projects to display.

Skills

  • No skills entered.

User Activity

  • Posted a comment on discussion Engineering πŸ‡¬πŸ‡§ on CODESYS Forge

    Someone please revert back... Kumar E

  • Posted a comment on discussion Engineering πŸ‡¬πŸ‡§ on CODESYS Forge

    I have a situation to use the CoDeSys supported PLC's... 1. Invt( https://www.invt.com/products/ax70-motion-controller-180). 2. Inovance ( http://en.inovance.cn/content/details120_16939.html) 3. Inovance (http://en.inovance.cn/content/details120_14141.html ). Now I want to use the CoDeSys IDE( https://store.codesys.com/en/codesys.html). I don't want to load many software into laptop. How to do? regards, Kumar E

  • Posted a comment on discussion Runtime πŸ‡¬πŸ‡§ on CODESYS Forge

    I think you are using Jetson board. Could you please let me know the following details... 1. What is the CoDeSys Runtime Module you used? 2. What is the OS? 3. What is the Jetson Board you have used? thanks & regards, EK

  • Posted a comment on discussion Runtime πŸ‡¬πŸ‡§ on CODESYS Forge

    The Sancloud BBB Industrial version is working with CoDeSys and EtherCAT master.

  • Posted a comment on discussion Engineering on CODESYS Forge

    I am trying to build the setup(CoDeSys + Panasonic A6 EtherCAT servo drive Model: MDDLN45BE) without softmotion module. I am trying to configure and run the setup by writing the values into servo parameters via EtherCAT. I have attached a screen shot of CoDeSys. Now I have the following questions... 1. (refer the attached file) Under setup parameter(RW-Read Write) we can configure the servo. Is it correct?. 2. IF the above is correct, then the servo parameters will be written from CoDeSys during...

  • Posted a comment on discussion Engineering on CODESYS Forge

    I am integrating a servo press unit with CoDeSys + Panasonic A6 EtherCAT servo drive(Model: MDDLN45BE). Anybody have done project with this combination. As off now Let me know what is the motion library to be used. Seeking help. Kumar.E

  • Posted a comment on discussion Runtime on CODESYS Forge

    Dave , What about the reliability with RPi4? I am trying to build an industrial application with BeagleBone Black. It has industrial version. I am not able to get good community support. Hence I am trying to switch over to RPi4. what is your recommendation for RPi4 for an industrial application? Thanks in advance.... Kumar

  • Posted a comment on discussion Runtime on CODESYS Forge

    Dave , What about the reliability with RPi4? I am trying to build an industrial application with BeagleBone Black. It has industrial version. I am not able to get good community support. Hence I am trying to switch over to RPi4. what is your recommendation for RPi4 for an industrial application? Thanks in advance.... Kumar

View All