Hi,
I want to use an Windows PC with Setup_CODESYSControlRTE64V3.5SP10.exe installed as an EtherCAT Master with two Nanotec motor controls as slaves:
When i log in my Device an Error pops up:
It says, that i have different versions of my device on my pc and in my project. i have to upgrade or downgrade the version in my project.
But i am using "CODESYS Softmotion RTE V3 x64 3.5.10.0" in my project and "CODESYS Control RTE V3 Version 3.5.10.0" an my pc. So i don't understand, why there is a version conflict.
After the error pops up, i have 8 errors of unresolved references, as you can see in the first picture.
Can someone help me please?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
hi,
you need to install the CODESYS Ethercat driver like you could read in the RTE manual..
(Windows Device Manager) and then add the component to the RTE configuration.
In your system there should be on of the following NIC (network interface) chipsets available:
Realtek 8139 (CmpRTL81x9Mpd)
Realtek RTL8139 (und kompatiblen) Ethernet-Contoller.
the 8100 und 8110 are compatible too.
Hi,
I want to use an Windows PC with Setup_CODESYSControlRTE64V3.5SP10.exe installed as an EtherCAT Master with two Nanotec motor controls as slaves:
When i log in my Device an Error pops up:
It says, that i have different versions of my device on my pc and in my project. i have to upgrade or downgrade the version in my project.
But i am using "CODESYS Softmotion RTE V3 x64 3.5.10.0" in my project and "CODESYS Control RTE V3 Version 3.5.10.0" an my pc. So i don't understand, why there is a version conflict.
After the error pops up, i have 8 errors of unresolved references, as you can see in the first picture.
Can someone help me please?
here is my project archive:
https://www.dropbox.com/sh/gx9sg0buwafa ... Zwmqa?dl=0 m
hi,
you need to install the CODESYS Ethercat driver like you could read in the RTE manual..
(Windows Device Manager) and then add the component to the RTE configuration.
In your system there should be on of the following NIC (network interface) chipsets available:
Realtek 8139 (CmpRTL81x9Mpd)
Realtek RTL8139 (und kompatiblen) Ethernet-Contoller.
the 8100 und 8110 are compatible too.
Realtek 8169 (CmpRTL8169Mpd)
Realtek 8169/810
Realtek RTL8111B / RTL8111D / RTL8111E
Intel EtherExpressPro1000 (CmpEt1000Mpd )
82541,82547,82567,82571,82573,82574,82583V, i210, i217-LM etc
Intel EtherExpress PRO/100 (CmpEt100Drv)
Intel 82551,82557,82559
Intel 82559, 82558, 82557 and 82550
BR
Edwin