Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hallo Florian,
nein das geht nicht, Profibus mit einem Rapsberry Pi geht nur über Beckoff EL6731 Ethercat Gateway Klemme. Du brauchst also eine EK1100 und EL6731(Master).
Grüße
Edwin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hallo,
ich versuche den oben genannten HAT in Codesys einzubinden.
https://www.waveshare.com/wiki/RS485_CAN_HAT
Gibt es eine Möglichkeit das Modul als Profibus Master einzubinden?
Wenn dies möglich ist, gibt es eine Anleitung irgendwo?
Bis jetzt habe ich ausschließlich mit V2.3 gearbeitet und dies mittels ABB, da hat man für alles eine passende GSD Datei :)
Grüße
Florian
Hallo Florian,
nein das geht nicht, Profibus mit einem Rapsberry Pi geht nur über Beckoff EL6731 Ethercat Gateway Klemme. Du brauchst also eine EK1100 und EL6731(Master).
Grüße
Edwin