Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

How to configure the libraries?

victor-p
2014-04-25
2014-04-28
  • victor-p

    victor-p - 2014-04-25

    I have the problem with configuring the libraries.
    It looks like this:
    I added the library IoDrvModus 3.5.1.0.
    It pulls a lot of other libraries with different version numbers, that are not in the installed repository.
    When I try change version by placeholder function , it could give a lot of errors.

    Question is: What is right way for solving this problem?
    If I have to use only the specified version number, how can it be to find?

     
  • eschwellinger

    eschwellinger - 2014-04-28

    Hi,

    usually the goal should be only add either modbus tcp or modbus com in the
    configuration (modbus tcp master under Ethernet Interface, modbus rtu under modbus com port), then all libraries should be addeded by the system.
    No need to do that manually in the library manager.
    Additional you need to specify which function codes you will use to read/write (Add Channels under the slave an then add the mapped variables)
    BR
    Edwin

    IMG: modbus_add_channels.jpg

    IMG: Modbus.jpg

     

Log in to post a comment.