Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi
Is there someone how have used EL3356 in V3 SP8. Startup parameters that will not be downloader in a proper way.
Have been recommended by our supplier write parameters using ETC_CO_SdoWriteDword.
It works but I also need to Read parameters when doing a sequence for Calibration.
Here I nee some help.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi
Is there someone how have used EL3356 in V3 SP8. Startup parameters that will not be downloader in a proper way.
Have been recommended by our supplier write parameters using ETC_CO_SdoWriteDword.
It works but I also need to Read parameters when doing a sequence for Calibration.
Here I nee some help.
hi,
this should point you in the right direction
http://store.codesys.com/ethercat-example.html
BR
Edwin