Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

gcode file

ZiadR
2009-02-16
2009-08-19
  • ZiadR - 2009-02-16

    hello

    is there any example on reading an external gcode file (txt format) instead of reading from cnc editor.

    thank you

     
  • eschwellinger

    eschwellinger - 2009-08-19

    Hello,

    ZiadR hat geschrieben:
    hello
    is there any example on reading an external gcode file (txt format) instead of reading from cnc editor.
    thank you

    See the attached jpg... and take care that you have a separate path-task (no file readings in the motion task!)

    cu

    Edwin Schwellinger

    IMG: ReadFile.jpg

     

Log in to post a comment.