I have the ESI file and I can set bits on the Ethercat in order to make it work I thouht maybe there's a library that can do the hard work instead like there is for a servo motor.
Thank you!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
if it is a DS402 compliant drive you could add by rightclick in the device tree a Softmotion device then Ds402 generic driver is used.Either Softmotion light or Softmotion is then possible - with using plcopen fb's
Last edit: eschwellinger 2021-08-22
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
What library should I use for VFD with Ethercat?
I have Delta C2000 and I can't find the library that support VFD.
Thanks!
Hello
you need the ESI file from Delta.
Then just add this device under the Ethercat master.
I doubt there's a specific library for a VFD.
I have the ESI file and I can set bits on the Ethercat in order to make it work I thouht maybe there's a library that can do the hard work instead like there is for a servo motor.
Thank you!
Hi,
if it is a DS402 compliant drive you could add by rightclick in the device tree a Softmotion device then Ds402 generic driver is used.Either Softmotion light or Softmotion is then possible - with using plcopen fb's
Last edit: eschwellinger 2021-08-22
How do I check if it's DS402 compliant?
Thanks!
Just rightclick on your added device try to add SoftMotion or SoftMotion light device...
In the ESI - ProfileNo should be 402.