CODESYS Forge - CODESYS Forge / Talk / Motion 🇬🇧: Step motor ECT60 Ethercat in codesys 3.5

Step motor ECT60 Ethercat in codesys 3.5

Forum: Motion 🇬🇧

Creator: andreiot40

Created: 2024-08-13

Updated: 2024-08-17

andreiot40 - 2024-08-13

I want to use my step motor with driver ECT60 Ethercat on CODESYS 3.5. All connexion is good because it work with Twincat 3.
But now I want to use that with CODESYS 3.5 but the communication doesn't work. someone can help me ?

cd6.1.png

cd6.2.png

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

dkugler - 2024-08-14

double click the master and the ECT60 and have a look what's shown in the tap online, state and log?

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- andreiot40 - 2024-08-15
  
  Thanks for your response.
  
  for Master in log i have : no slaves found, Interface could not be opened, could not open network adapters.
  
  Status : Not running
  
  FOR ETC60 There is nothing !!!
  
  Last edit: andreiot40 2024-08-15
  
  cd6.3.png
  
  cd6.4.png
  
  cd6.5.png
  
  cd6.6.png
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

eschwellinger - 2024-08-16

for Control Win you need to have installed Npcap
https://www.winpcap.org
then it will work

👍
1

Last edit: eschwellinger 2024-08-16

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- andreiot40 - 2024-08-17
  
  Thank you so much ! It works, I have communication.
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.