Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am facing issue with codesys soft PLC for communicating over Profinet. I have installed NPCap software. Attached image for reference. Error is RPC rejected: Unknown interface.
Unable to understand reason.
uninstall npcap..use latest available winpcap from winpcap.org, then it will work on Control Win plc. https://www.winpcap.org/install/default.htm
The last official WinPcap release was 4.1.3
Last edit: eschwellinger 2021-12-10
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I am facing issue with codesys soft PLC for communicating over Profinet. I have installed NPCap software. Attached image for reference. Error is RPC rejected: Unknown interface.
Unable to understand reason.
Last edit: ktillu 2021-12-10
uninstall npcap..use latest available winpcap from winpcap.org, then it will work on Control Win plc.
https://www.winpcap.org/install/default.htm
The last official WinPcap release was 4.1.3
Last edit: eschwellinger 2021-12-10
Thanks for your reply, I downloaded available Latest version WinPcap 4.1.3.
Unfortunately, same error is present.
On Fri, 10 Dec, 2021, 20:29 eschwellinger, forge@codesys.com wrote:
check the plc logger for more information
Last edit: eschwellinger 2021-12-11