Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Raspberry Pi PLC

timfruit
2021-07-07
2021-07-08
  • timfruit - 2021-07-07

    Hi

    I'm trying to create a PLC on my Raspberry Pi for testing a Profinet device I'm working on. I have a few warnings which seem to be stopping me from controlling my device. Can anyone shed any light on the warning? I have tried controlling my device with ladder logic but presuming it's these errors preventing me getting things up and running. (i've redacted a couple of words in the image as they happened to have client details on)

     
  • eschwellinger

    eschwellinger - 2021-07-07

    Hi,
    did you scan this pn device by rightclick in the device tree and add it that way?
    Best Regards
    Edwin

     
  • timfruit - 2021-07-08

    Hi Edwin,

    Thanks for your reply. Yes, that's the way i added the device. If i click on the screen now i see this information... as you can see there is a warning here but when i added everything it all seemed to appear in the device tree as expected

     
  • timfruit - 2021-07-08

    There is also this screen showing 'the bus is not running' - see screenshot

     
  • timfruit - 2021-07-08

    There is also this screen showing 'the bus is not running' - see screenshot

     
  • eschwellinger

    eschwellinger - 2021-07-08

    ...then the modules (identified via MdouelIdentNr and/or SubmoduleIdentNr) are not defined in the GSDMl...!

     

    Last edit: eschwellinger 2021-07-08
  • timfruit - 2021-07-08

    Thanks Edwin,

    I have used PROFINET master simulator to control this pump with it's GSDML file successfully though? Perhaps there is some other reason for the error?

     
  • eschwellinger

    eschwellinger - 2021-07-08

    no idea at the moment without a deeper investigation.

     
  • timfruit - 2021-07-08

    Is there anything else i can post to help?

     
  • timfruit - 2021-07-08

    Is there anything else i can post to help?

     

Log in to post a comment.