Hi, when it comes about license, I used INVTmatic Studio, which uses Codesys, for programming INVT plc. I bought Codesys Modbus license, it was not expensive, and then realised that INVT didn't have License Manager option (greyed out in program) which is needed for using of Codesys License. I contacted support from INVT, but developers told me that option is still not available. So depending on environment for programming Codesys, you can or not use Modbus license. Good thing about this version of...
Hi, did you solve this thing with license? I have similar issue with modbus tcp slave... I installed license for library but same again.
Hi, did you solve this thing with license? I have similar issue with modbus tcp slave... I installed license for library but same again.
Thanks for answer. But I don't have too many variables. Regards
Thank you so much for your answer, but for me it is not possible to open License Manager, only License Depository. License Manager is greyed out, so I cannot get into it. Not sure if it is up to the INVTmatic studio...
\Hi, did you solve this? I have similar issue with modbus tcp slave...
Hi, I have similar issue, did you solve this?
Hi, I have implemented Modbus TCP Slave, that works. But only 30 minutes and then we have to shut down PLC and reboot. I used INVTMatic studio, PLC is AX70, and library for Modbus Slave is from 3S - Smart SW Solutions Gmbh. So that solution functions but I have orange flag next to it. That means that it is running in demo mode. I was thinking this means I need license. I also bought license on 3S , but still same thing and same fault. Anybody tried something similar?