Activity for xabier
-
xabier posted a comment on discussion Engineering 🇬🇧
I bought two license and install with out problems....but the problem was when i changed the image in my controler and when i want activated again the license i have a problem Appear this 2 softcontainer and i can´t install any license again... Can someone help me please?
-
hi Getdone I have the same problem with you...Could resolved this problem?? Can you move with more speed??... I have cicle time 1 ms and the moment increase speed >5mm/s the FB SMC_Interpolator not fine work....Tell me plese if you resolved this problem Thanks Regards XABI
-
Hi, I want write a array with line break in file.txt (I attacehd the screen array) and when i check the file appear with white spaces (I attached file .txt ) Somepeople know how remove this white spaces?? Thanks you Regars XABI
-
Hi, I want write a array with line break in file.txt (I attacehd the screen array) and when i check the file appear with white spaces (I attached file .txt ) Somepeople know how remove this white spaces?? Thanks you Regars XABI
-
I have declarated this variable...When i use the variable I see all...I wan see only the variable not all. For example I declarated in GVL_GLOBAL ==> Torque_Mode When I push enter insert in code all rute..GVL_GLOBAL.Torque_MOde...I want see only torque mode...How is possible resolved this problem?? Thanks XABI
-
Please...can you help me???I don´t understand...Where check it that you tell me ??Where appear Pdf??? I need more support thanks
-
I atached other photo
-
YEs..This drive supported Softmotion... I attaced the photos...for example with this driver can i move in absolute mode but i can´t aplicated FB set Torque and the 2 FB are down the same libre SM3_Basic
-
I want implement a Control torque with limit speed..Now I use the FB SMC_SetTorque and SMC_SetControllerMode and not fine work...not moving
-
I have a Control Techniques M751 driver that I'm controlling with a codesys-based PLC.... I want to implement a rate-limiting torque control. How could I do it??.. Is there any FB from codesys that allows me to do it?? Thank you
-
I have a Control Techniques M751 driver that I'm controlling with a codesys-based PLC.... I want to implement a rate-limiting torque control. How could I do it??.. Is there any FB from codesys that allows me to do it?? Thank you