SuperImpose worked after correcting the Acceleration and Deceleration..
Hi All, I have a packing machine project and I have to make a bobbin feed system with a mark sensor. If I make the system CAM or Gear in right conditions it works great for my master and slave axis. But when I'm trying to play with axis with MC_Phasing ( I do the recomendation on MC_Phasing help article I use a virtual axis for real CAM). AX1 -- 0-360 master exis AX2 -- Virtual Master Axis Geared to Axis 1 to 1 AX3 -- Slave axis AX1 GEARED AX2 AX2 GEARED AX3 AX1 Phase Shift AX2 First Problem when...
Thank's A LOT it worked.. :)
Hi All, I have a servo motor axis can be accepted as no load on it. The motor moving at 15000 mm/s with MC_MoveVelocity (Speed can change) If I give MC_Stop to the same axis with deceleration 45000 I want to calculate the length that motor stop, before I give the MC_Stop command.. Do we have a formula to calculate it? Best Regards
Thanks A lot..
Hi All, I'm using CodeSys Softmotion Ethercat on HCFA controller.. Is it possible to change the SlaveScaling without CamOut in a camming system or any useful ideas that not requre CamOut ? -- Bu e-posta virüslere karşı Avast antivirüs yazılımı tarafından kontrol edilmiştir. https://www.avast.com/antivirus