Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am using Control RTE with softmotion Dirve (Schneider LXM32 series Ethercat fieldbus). I need to use the Touchprobe FB but not sure how to fill 'Trigger_Ref'. I cannot find any document from schneider and hopefully can get some detail info from Codesys. What is 'iTriggerNumber' in the 'Trigger_Ref'? is it a Digital input number?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
there should be a description ( pdf) embedded in the Lexium32 library.
(Check this in the LibraryManager-Lexiuim.library) this should help to to set this.
Last edit: eschwellinger 2020-09-12
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I am using Control RTE with softmotion Dirve (Schneider LXM32 series Ethercat fieldbus). I need to use the Touchprobe FB but not sure how to fill 'Trigger_Ref'. I cannot find any document from schneider and hopefully can get some detail info from Codesys. What is 'iTriggerNumber' in the 'Trigger_Ref'? is it a Digital input number?
Hi,
there should be a description ( pdf) embedded in the Lexium32 library.
(Check this in the LibraryManager-Lexiuim.library) this should help to to set this.
Last edit: eschwellinger 2020-09-12
see here:
Hello here you could find some good videos about Softmotion with LXM32M and EtherCAT
https://www.youtube.com/channel/UCeOa8aEiV8CdAO9dCp7PATA